Lincoln Corsair: Supplemental Restraint System / Removal and Installation - Seat Position Sensor
Removal
NOTE:
LH (left-hand) seat shown, RH (right-hand) seat similar.
NOTE:
Removal steps in this procedure may contain installation details.
-
Raise the front seat to the full up position.
-
-
Disconnect the seat position sensor electrical connector.
-
Remove the seat position sensor screw.
Torque:
8 lb.in (0.9 Nm)
-
Remove the seat position sensor.
Installation
-
To install, reverse the removal procedure.
Removal
WARNING:
The following procedure prescribes critical repair steps
required for correct restraint system operation during a crash. Follow
all notes and steps carefully...
Removal
WARNING:
The following procedure prescribes critical repair steps
required for correct restraint system operation during a crash. Follow
all notes and steps carefully...
Other information:
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
Remove the driver door window control switch and bezel as an assembly.
Release the clips.
Use the General Equipment: Interior Trim Remover
Disconnect the driver door window control switch electrical connector...
Check
NOTE:
Refer to the appropriate Section 303-01 for the specification.
NOTE:
Crankshaft main bearing journals must be within specifications before checking journal clearance.
Remove the crankshaft main bearing cap and crankshaft main bearing...