Lincoln Corsair: Seatbelt Systems / General Procedures - Seatbelt Cleaning
Cleaning
WARNING:
Do not bleach or re-dye the seatbelt webbing, as the webbing
may weaken. Failure to follow this instruction may increase the risk of
serious personal injury or death in a crash.
-
Refer to the owner's literature for information on
seatbelt care and the recommended cleaning solution to use. Follow the
manufacturer's instructions provided with the cleaning solution.
Repair
NOTE:
If the seatbelt webbing does not extract from the seatbelt
retractor from the stowed position, this may be due to a normal
condition which happens when the seatbelt retracts at a high rate of
speed...
Inspection
WARNING:
All seatbelt components must be inspected and corrected as
part of any collision repair. Inspect all seatbelt components as
prescribed by Seatbelt Procedure After a Collision found in Section
501-20A General Procedures of this manual...
Other information:
Removal
NOTE:
LH (left-hand) side shown, RH (right-hand) side similar.
Remove the front door latch.
Refer to: Front Door Latch (501-14 Handles, Locks, Latches and Entry Systems, Removal and Installation).
NOTE:
This step is only necessary when installing a new component...
Materials
Name
Specification
Motorcraft® Ultra-Clear Spray Glass CleanerZC-23
ESR-M14P5-A
Repair
Bring the vehicle up to at least the specified room temperature or above.
NOTE:
The new terminal covers the original terminal
location, but it must be placed so the terminal conductive areas will be
placed on a good conductive base...