Lincoln Corsair: Vehicle Dynamic Suspension / Removal and Installation - Vehicle Dynamics Control Module (VDM)

Removal

NOTICE: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.

NOTE: Removal steps in this procedure may contain installation details.

1. NOTE: The current PMI process must begin with the current VDM installed. If the current VDM does not respond to the diagnostic scan tool, the tool may prompt for As-Built Data as part of the repair.

   Using a diagnostic scan tool, begin the PMI process for the VDM following the on-screen instructions.
   

1. Remove the RH loadspace trim panel.
   Refer to: Loadspace Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
   

1. 
   Remove the VDM .
   
   1. Disconnect the electrical connectors.
      
   2. Remove the retainers and the VDM .
      Torque: 13 lb.in (1.5 Nm)

Installation

1. To install, reverse the removal procedure.
   

1. Using a diagnostic scan tool, complete the PMI process for the VDM following the on-screen instructions.
   

1. Calibrate the VDM . Connect the scan tool and carry out the Ride Height Calibration routine. Follow the scan tool directions.