Lincoln Corsair: Vehicle Dynamic Suspension / Removal and Installation - Front Suspension Height Sensor

Special Tool(s) / General Equipment

Removal

NOTE: Removal steps in this procedure may contain installation details.

1. Remove the wheel and tire.
   Refer to: Wheel and Tire (204-04A Wheels and Tires, Removal and Installation).
   

1. NOTE: Note the position of the components before removal.

   NOTE: LH (left-hand) height sensor assembly shown, RH (right-hand) similar.

   
   Remove the front suspension height sensor.
   
   1. Disconnect the front suspension height sensor electrical connector, Unclip the harness and position aside.
      
   2. Remove the front suspension height sensor arm bracket-to-lower arm retainer.
      Torque: 97 lb.in (11 Nm)
   3. Drill out the retaining rivets and remove the front suspension height sensor.
      Use the General Equipment: 6.5 mm Drill Bit
      Use the General Equipment: Electric Drill
      Use the General Equipment: Rivet Gun

Installation

1. NOTICE: The linkage must be in a vertical position after installation. Failure to follow these instructions may result in component damage and/or failure.

   NOTE: The RH (right-hand) and LH (left-hand) height sensor assemblies cannot be used on opposite sides of the vehicle.

   To install, reverse the removal procedure.
   

1. Calibrate the suspension height sensor. Connect the scan tool and carry out the Ride Height Calibration routine. Follow the scan tool directions.