Lincoln Corsair: Front Seats / Removal and Installation - Front Seat Backrest Blower Motor
Removal
NOTE:
Driver seat shown, passenger seat similar.
-
Remove the front seat.
Refer to: Front Seat (501-10A Front Seats, Removal and Installation).
-
Remove the front seat backrest panel.
Refer to: Front Seat Backrest Panel (501-10A Front Seats, Removal and Installation).
-
Disconnect the front seat backrest blower motor electrical connector.
-
Detach the retainer.
-
Detach the retainer.
-
Disconnect the front seat backrest blower motor electrical connector.
-
Rotate the front seat backrest blower motor 45 degrees clockwise and remove.
Installation
-
To install, reverse the removal procedure.
Removal
WARNING:
The following procedure describes critical repair steps
required for correct seat component installation. Follow all notes and
steps carefully...
Special Tool(s) /
General Equipment
Interior Trim Remover
Hog Ring Plier
Removal
NOTE:
Driver seat shown, passenger seat similar.
Remove the front seat...
Other information:
Removal
NOTICE:
Do not loosen any fittings or plugs on the high-pressure fuel pump.
With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
Release the fuel system pressure...
Special Tool(s) /
General Equipment
Fluid Container
Draining
With the vehicle in NEUTRAL, position it on a hoist.
Refer to: Jacking and Lifting - Overview (100-02 Jacking and Lifting, Description and Operation).
NOTE:
Less than half of the fluid may be drained from the
rear electric drive assembly...