Lincoln Corsair: Glass, Frames and Mechanisms / Removal and Installation - Front Door Window Regulator Motor
Removal
NOTE:
Left hand (LH) shown, right hand (RH) similar.
NOTE:
For front door window regulator motors that are
non-functional it may be necessary to remove the front door window
regulator motor prior to securing the front door window glass.
-
Remove the front door trim panel.
Refer to: Front Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
-
NOTICE:
Damage to the front door window glass may occur if not secured.
Secure the front door window glass with tape.
-
Remove the front door window regulator motor.
-
Disconnect the front door window regulator motor electrical connector.
-
Remove the bolts and the front door window regulator motor.
Installation
-
To install, reverse the removal procedure.
-
Carry out the power door window initialization.
Refer to: Power Door Window Initialization (501-11 Glass, Frames and Mechanisms, General Procedures).
Special Tool(s) /
General Equipment
Punch
Removal
WARNING:
The following procedure prescribes critical repair steps
required for correct restraint system operation during a crash...
Removal
Remove the passenger door window control switch bezel assembly.
Release the locking tabs from the passenger door window control switch bezel assembly...
Other information:
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Open the glove compartment.
Depress the stop tabs and lower the glove comaprtment.
Remove the dampener strap.
Fully lower the glove compartment, and the glove compartment off the hinges...
The front outboard and rear safety restraints
in the vehicle are combination lap and
shoulder belts.
Insert the belt tongue into the proper
buckle (the buckle closest to the direction
the tongue is coming from) until you hear
a snap and feel it latch...