Lincoln Corsair: Glass, Frames and Mechanisms / Removal and Installation - Front Door Window Glass
Special Tool(s) /
General Equipment
Removal
NOTE:
LH (left-hand) side shown, RH (right-hand) side similar.
-
Remove the front door trim panel.
Refer to: Front Door Trim Panel (501-05 Interior Trim and Ornamentation, Removal and Installation).
-
Remove the front door window glass release access covers.
-
Lower the front door window glass to the half down position.
-
Connect the window control switch.
-
Lower the front door window glass to the half down position.
-
Disconnect the window control switch.
-
Remove the front door outer belt moulding screw.
-
Release the pin-type retainer and position the front door glass top run aside.
-
Remove the front door outer belt moulding screw.
Torque:
12 lb.in (1.3 Nm)
-
Remove the front door outer belt moulding screw.
-
Position the front door glass top run aside to access the front door outer belt moulding screw.
-
Remove the front door glass top run screw.
Torque:
12 lb.in (1.3 Nm)
-
Remove the front door outer belt moulding.
-
Remove the front door upper trim.
-
Remove the pin-type retainers.
-
Release the front door upper trim.
-
Release the front door upper trim.
-
Release the front door upper trim.
-
Remove the front door upper trim.
-
Remove the front door inner belt moulding.
-
NOTE:
For the right hand side, rotate the front door window glass 45 degrees counter-clockwise.
Remove the front door window glass.
-
Release the front door window glass retaining clips.
Use the General Equipment: Punch
-
Rotate the front door window glass 45 degrees clockwise.
-
Remove the front door window glass.
Installation
-
To install, reverse the removal procedure.
-
Carry out the power door window initialization.
Refer to: Power Door Window Initialization (501-11 Glass, Frames and Mechanisms, General Procedures).
Removal
NOTE:
LH (left-hand) side shown, RH (right-hand) side similar.
NOTE:
Removal steps in this procedure may contain installation details.
Remove the front door window glass...
Special Tool(s) /
General Equipment
Punch
Removal
WARNING:
The following procedure prescribes critical repair steps
required for correct restraint system operation during a crash...
Other information:
Passive Anti-Theft System
What Is the Passive Anti-Theft System
The passive anti-theft system prevents
someone from starting the vehicle with an
incorrectly coded key.
Arming the Passive Anti-Theft System
The passive anti-theft system arms your
vehicle after a short period of time when you
switch the power off...
Removal
Remove the brake disc.
Refer to: Brake Disc (206-04 Rear Disc Brake, Removal and Installation).
Remove the retainer and bolt and position the wheel speed sensor aside.
Remove and discard the wheel bearing and wheel hub bolts...