Lincoln Corsair Manuals

Lincoln Corsair: Evaporative Emissions - 2.0L EcoBoost (177kW/240PS) – MI4 / Removal and Installation - Evaporative Emission Blocking Valve

Removal

NOTE: The evaporative emission blocking valve is serviced with the fuel tank pressure sensor and tube.

  1. Refer to: Fuel Tank Pressure Sensor and Tube (303-13A Evaporative Emissions - 2.0L EcoBoost (177kW/240PS) – MI4, Removal and Installation).

Installation

  1. To install, reverse the removal procedure.

    General Procedures - Evaporative Emission System Leak Test

    Activation Phase 1 - Leak Verification Run the EVAP Test with the scan tool. NOTE: Some small leaks may not be detected using the EVAP Test...

    Removal and Installation - Evaporative Emission Canister

    Removal   WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component...

    Other information:

    Lincoln Corsair 2020-2025 Service Manual: Removal and Installation - Rear Door Window Regulator and Motor


    Special Tool(s) / General Equipment Punch Removal NOTE: Left hand (LH) shown, right hand (RH) similar. NOTE: For rear door window regulator motors that are non-functional it will be necessary to remove the rear door window regulator motor prior to removing the rear door window regulator...

    Lincoln Corsair 2020-2025 Service Manual: General Procedures - Roof Opening Panel Alignment


    Adjustment Measurement Measure the roof opening panel movable glass height/flushness. Measure the roof opening panel sliding glass front edge-to-header panel height/flushness. Refer to the specifications as shown. Measure the roof opening panel sliding glass rear edge-to-roof opening panel fixed glass height/flushness...

    Categories

    Selecting a Drive Mode. DRIVE MODES

    Selecting a Drive Mode

    Note: Drive mode changes may not be available when the ignition is off.

    Lincoln Corsair. Selecting a Drive Mode. DRIVE MODES

    read more

    Copyright © 2025 www.licorsair.com