Lincoln Corsair: Automatic Transmission - Automatic Transmission – HF45 / Disassembly and Assembly of Subassemblies - Transmission High Voltage Terminals
DISASSEMBLY
-
Disconnect the high voltage inductor.
-
Remove the bolts and the high voltage inductor.
-
Remove the high voltage bolts.
-
Remove the bolts and the high voltage terminals.
ASSEMBLY
-
Install the high voltage terminals and the bolts.
Torque:
97 lb.in (11 Nm)
-
Install the high voltage terminal bolts.
Torque:
89 lb.in (10 Nm)
-
Install the high voltage inductor and the bolts.
-
Torque:
18 lb.ft (25 Nm)
-
Torque:
89 lb.in (10 Nm)
-
Connect the high voltage inductor.
Materials
Name
Specification
Motorcraft® MERCON® ULV Automatic Transmission FluidXT-12-QULV
WSS-M2C949-A, MERCON® ULV
DISASSEMBLY
Remove the bolts and the pump assembly...
Special Tool(s) /
General Equipment
204-029Drawbar
205-153
(T80T-4000-W)
Handle
307-541Installer, Transfer Gear BearingTKIT-2005D1-F
307-591Shim Gauge, Differential/Transfer Gear BearingTKIT-2006UF-FLMTKIT-2006UF-ROW
307-672Installer, Input Guide and SealTKIT-2010D-FLMTKIT-2010D-ROW
307-680Table, Assembly (DPS6)TKIT-2010D-FLMTKIT-2010D-ROW
307-741..
Other information:
Special Tool(s) /
General Equipment
Interior Trim Remover
Removal
NOTE:
Removal steps in this procedure may contain installation details.
Remove the rear seat armrest.
Refer to: Rear Seat Armrest (501-10B Rear Seats, Removal and Installation).
Remove the rear head restraint guide sleeves.
Refer to: Rear Head Restraint Guide Sleeve (501-10B Rear Seats, Remov..
Gate Operator / Canadian Programming
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit) after
several seconds of transmission – which may
not be long enough for HomeLink to pick up
the signal during programming. Similar to
this Canadian law, some U.S. gate operators
“time-out” in the same manner.
Note: If programming a garage door opener
or gate oper..